WorkWindow

Roof Coating Weather in Mississippi: Best Months by City

Roof Coating season in Mississippi, city by city: peak months, season boundaries, and annual workable-day counts from NOAA 1991–2020 normals. Gulfport leads with 219 workable days a year; Jackson runs the shortest at 159.

Mississippi is not one climate: Gulfport banks 219 workable roof coating days a year while Jackson gets 159 — a spread the table below itemizes month by month. Season boundaries mark the first and last month averaging 8+ workable days against the label rules (50–90°F, nights 40°F+).

If one month anchors the Mississippi calendar it's October, the statewide leader in workable days. Use this page to pick the month, then the city page's 10-day strip to pick the days — and the national roof coating guide for the physics behind each rule.

Cities in Mississippi

Peak months and season boundaries from NOAA 1991–2020 normals; season = months with at least 8 workable days.
CityPeak monthsSeasonWorkable days/yr
Jackson Oct, May, Nov February–June 159
Gulfport Oct, May, Apr September–June 219
Hattiesburg Oct, Nov, May February–June 166

The rules behind these numbers

Typical label thresholds for roof coating — the single ruleset used by every check on this page.
CheckThresholdWhy it matters
Air temperature 50–90°F Acrylic and elastomeric coatings want 50°F+ during application and initial cure.
Overnight low ≥40°F during the first 24 h Water-based coatings can be ruined by a cold, damp night before they skin over.
Dry before ≤0.05" rain in the prior 24 h; watch back to 48 h The membrane must be dry — coatings trap moisture that later blisters.
Dry after <0.05" rain for 24 h after (48 h thick coats want 48 h) Rain inside 24 hours washes uncured coating into gutters.
Evening dew-point spread ≥5°F from 6–11 pm Roofs radiate heat at night and hit the dew point before anything else in the yard.
Daytime humidity ≤85% Humid air slows water-based coatings dramatically.
Wind ≤15 mph (roller only, no spray up to 20 mph) Wind on a roof is a safety limit first and an overspray limit second.

Always follow your product label — formulas vary. The table above is the typical range across major manufacturers, not a promise about your can.

Other tasks in Mississippi

More