Concrete Pouring Weather in Augusta, GA: 10-Day Windows & Best Months
The concrete pouring season in Augusta runs March through May — 6 months averaging at least 8 workable days by NOAA 1991–2020 normals. The single best month is October, averaging 24 days that clear every check — highs of 79°F, lows near 53°F, and a 22% daily rain chance. Below: today through day 10 against the label rules, then the year at a glance.
GOOD — every label check passes MARGINAL — one soft fail NO — hard fail or several soft
The rules this check uses
The Augusta strip runs on these rows — bagged-mix consensus for DIY-scale work, ruled by the 48-hour freeze check. Structural pours answer to an engineer and ACI, not to this page.
| Check | Threshold | Why it matters |
|---|---|---|
| Air temperature | 40–90°F — ideal 50–85°F | The film (or mix) chemistry runs on temperature — both while you work and for the first hours after. |
| Overnight low | ≥40°F during the first 48 h | Curing continues after dark; the first night can undo a perfect afternoon. |
| Dry before | no soaking (≥1.0") in the prior 24 h | Checked backward from your start hour using the two look-back days in the forecast data. |
| Dry after | <0.1" rain for 6 h after (12 h light rain after finishing still risks surface marks) | The engine sums forecast rain hour by hour through the cure window for Augusta. |
| Wind | ≤20 mph (rapid surface drying up to 28 mph) | Hot wind pulls bleed water out faster than the slab can handle. |
Always follow your product label — formulas vary. The table above is the typical range across major manufacturers, not a promise about your can.
Best months for concrete pouring in Augusta
| Month | Avg high | Avg low | Rain odds/day | Workable days | |
|---|---|---|---|---|---|
| January | 60°F | 35°F | 32% | 0 | |
| February | 64°F | 38°F | 31% | 3 | |
| March | 71°F | 44°F | 28% | 22 | |
| April | 78°F | 51°F | 26% | 22 | |
| May | 86°F | 60°F | 27% | 23 | |
| June | 91°F | 68°F | 35% | 4 | |
| July | 94°F | 72°F | 36% | 0 | |
| August | 93°F | 71°F | 35% | 0 | |
| September | 88°F | 65°F | 26% | 19 | |
| October | 79°F | 53°F | 22% | 24 | |
| November | 69°F | 42°F | 23% | 19 | |
| December | 62°F | 37°F | 30% | 0 |
Figure 137 workable days a year in Augusta, spread across March through May. Shoulder months turn on the overnight rule: an afternoon at 71°F passes, but the 40°F night floor is what actually opens the season in March. The Georgia table ranks every listed city by the same math.
July here fails on heat, not rain: the average high of 94°F sits over the 90°F label ceiling, and 31 of 31 days typically top 90°F. Midsummer work moves to dawn or waits for October.
Sealing the same driveway later? Sealcoating in Augusta wants warmer nights (50°F+) than the pour did.
Source honesty: every monthly figure on this page is the 1991–2020 normal at Augusta Bush Fld Ap, Ga Us, 10.0 km from Augusta's center — your block's shade lines and wind exposure sit on top of that baseline. Scoring details are on the methodology page.
Augusta by the numbers
- Hottest month: July — 94°F average high, 31 days topping 90°F.
- The cold floor is January at 60°F afternoons and 35°F overnight.
- Measurable rain: July leads at 36% of days; October is the quiet end at 22%.
- The 40°F-night season spans March–November here.
- Bottom line for Augusta: roughly 137 workable concrete pouring days a year.
Prep checklist
- Clear the 48-hour rule first: two nights over 40°F. March opens that door in Augusta; January (35°F average lows) slams it.
- Nothing gets mixed until the site is staged — braced forms, compacted damp base, rinsed tools, a second pair of hands.
- Cut plastic sheeting and weight it at the pour's edge — Augusta sees rain on 22% of October days, and the 6-hour rule doesn't negotiate.
- Mix to a low slump — thick oatmeal, not soup; extra water now is a weak surface forever.
- Timing beats muscle — screed wet, float at the dull stage, and never chase bleed water with a trowel.
- Edge and joint with an edger + float set — control joints every 2–3 slab-thicknesses in feet.
- Hold the moisture in (sheeting or misting); when May nights dip toward 60°F, a curing blanket is the difference.
- Keep feet off 24–48 hours and cars off a week; structural pours follow the engineer and ACI, full stop.
Gear that saves a window
Transparency note: gear links here become affiliate links only when the program is enabled — today they are plain references. See the affiliate disclosure.
-
Edger + float set
Rounded edges and a flat surface before it sets.
-
Curing blanket
Holds heat through cold nights in the critical 48 hours.
-
Concrete mix
An 80-lb bag yields about 0.6 cu ft — do the math twice.
-
IR surface thermometer
Track slab temperature, not just the forecast.
FAQ
What temperature is too cold to pour concrete?
The line is a 40°F low inside the first 48 hours; an actual freeze (32°F) physically damages young concrete. Augusta's January nights average 35°F — firmly out — while October nights hold near 53°F. Small pours only; structural work follows engineer/ACI specs.
Can you pour concrete before rain?
The engine wants 6 protected hours; light rain later actually feeds the cure. With 36% rain-day odds in July versus 22% in October, Augusta's dry-season pours barely think about this rule and wet-season pours live by the radar. For small DIY pours; structural schedules follow ACI.
How long does concrete need to be protected from freezing?
Keep it above freezing for at least the first 48 hours (the engine calls any sub-40°F low in that window a NO). In Augusta that rules out roughly January-adjacent months entirely and makes shoulder-season pours a two-night forecast decision. DIY scope; anything structural follows engineer/ACI cold-weather practice.
Is it OK to pour concrete in hot weather?
To a 90°F high, yes — with shade, cool mix water, a damp subgrade, and a dawn start. Above 90°F the surface sets while the core is plastic and shrinkage cracks map the slab. Augusta averages 31 such days in July, which is why summer pours here move to first light.
How long before you can drive on new concrete?
A week before tires, 24–48 hours before feet — at October-typical Augusta temperatures (79°F highs). When nights slide toward 35°F, add days: cure speed is temperature. Early loads print permanent marks; the bag's cure table wins every argument.
Best season for concrete work in Augusta?
March through may — the months with 40°F+ nights, sub-90°F days, and manageable rain. October leads at 24 workable days; January bottoms out near 0.
Related
Other projects in Augusta
- Deck Staining in Augusta
- Exterior Painting in Augusta
- Driveway Sealing in Augusta
- Roof Coating in Augusta
- Lawn Seeding in Augusta
- All outdoor project weather in Augusta
Concrete Pouring nearby
- Columbia, SC
- Athens, GA
- Mauldin, SC
- Macon, GA
- Greenville, SC
- Savannah, GA
- Warner Robins, GA
- Spartanburg, SC
Guides
Climatology: NOAA 1991–2020 normals via AUGUSTA BUSH FLD AP, GA US (10.0 km from Augusta center, elevation 132 ft); live outlook by Open-Meteo.