WorkWindow

Deck Staining · Mississippi

Deck Staining Weather in Hattiesburg, MS: 10-Day Windows & Best Months

In Hattiesburg, the label math works from February through June: that's the stretch with 8+ workable days a month against typical deck staining rules. The single best month is October, averaging 24 days that clear every check — highs of 79°F, lows near 56°F, and a 22% daily rain chance. The strip above runs Hattiesburg's live forecast; the table below ranks all 12 months.

Best month: May · 22 workable days

The next 10 days in Hattiesburg

GOOD — clears every rule MARGINAL — exactly one soft miss NO — a hard fail, or two soft

The rules this check uses

The strip above scores Hattiesburg's forecast against exactly these rows — typical numbers across stain manufacturers, oil formulas simply stretching the dry-after hours.

Typical label thresholds for deck staining — the ruleset behind every Hattiesburg verdict above.
CheckThresholdWhy it matters
Air temperature 50–90°F Checked across the working day, 8 a.m.–6 p.m., against Hattiesburg's hourly forecast — not just the daily high.
Overnight low ≥40°F during the first 24 h The engine reads every overnight hour in the cure window, not just Hattiesburg's forecast low.
Dry before ≤0.05" rain in the prior 24 h; watch back to 48 h Wood must dry out after rain before it can absorb stain.
Dry after <0.05" rain for 24 h after (48 h oil-based formulas want 48 h dry) Water-based stains need roughly 24 dry hours; oil-based closer to 48.
Evening dew-point spread ≥5°F from 6–11 pm Scored on the worst hour between 6 and 11 p.m., when surfaces cool past the air.
Daytime humidity ≤85% Daytime relative humidity slows dry time.
Wind ≤15 mph (brush or pad only up to 20 mph) Wind wrecks application first (drift, lap marks) and carries debris into wet work second.

Always follow your product label — formulas vary. These rows are the industry-typical range; the can in your Hattiesburg garage is the contract.

Best months for deck staining in Hattiesburg

January: 0 workable days · high 60°F / low 38°F · rain 36% of daysFebruary: 13 workable days · high 64°F / low 41°F · rain 36% of daysMarch: 21 workable days · high 71°F / low 48°F · rain 31% of daysApril: 22 workable days · high 78°F / low 54°F · rain 27% of daysMay: 22 workable days · high 84°F / low 62°F · rain 28% of daysJune: 10 workable days · high 90°F / low 70°F · rain 38% of daysJuly: 0 workable days · high 91°F / low 72°F · rain 42% of daysAugust: 0 workable days · high 91°F / low 72°F · rain 36% of daysSeptember: 19 workable days · high 88°F / low 67°F · rain 28% of daysOctober: 24 workable days · high 79°F / low 56°F · rain 22% of daysNovember: 22 workable days · high 69°F / low 46°F · rain 25% of daysDecember: 12 workable days · high 62°F / low 40°F · rain 33% of daysJanuary avg high 60°FJanuary avg low 38°FFebruary avg high 64°FFebruary avg low 41°FMarch avg high 71°FMarch avg low 48°FApril avg high 78°FApril avg low 54°FMay avg high 84°FMay avg low 62°FJune avg high 90°FJune avg low 70°FJuly avg high 91°FJuly avg low 72°FAugust avg high 91°FAugust avg low 72°FSeptember avg high 88°FSeptember avg low 67°FOctober avg high 79°FOctober avg low 56°FNovember avg high 69°FNovember avg low 46°FDecember avg high 62°FDecember avg low 40°FJanuary: rain on 36% of daysJFebruary: rain on 36% of daysFMarch: rain on 31% of daysMApril: rain on 27% of daysAMay: rain on 28% of daysMJune: rain on 38% of daysJJuly: rain on 42% of daysJAugust: rain on 36% of daysASeptember: rain on 28% of daysSOctober: rain on 22% of daysONovember: rain on 25% of daysNDecember: rain on 33% of daysD38°64°91°013212222100019242212
Workable days (bar height)Avg high °FAvg low °FRain odds (dot size)
Workable days in Hattiesburg, MS: days meeting the temperature rules, discounted by NOAA rain odds — a 1991–2020 estimate, not a forecast.
MonthAvg highAvg lowRain odds/dayWorkable days 
January 60°F 38°F 36% 0
February 64°F 41°F 36% 13
March 71°F 48°F 31% 21
April 78°F 54°F 27% 22
May 84°F 62°F 28% 22
June 90°F 70°F 38% 10
July 91°F 72°F 42% 0
August 91°F 72°F 36% 0
September 88°F 67°F 28% 19
October 79°F 56°F 22% 24
November 69°F 46°F 25% 22
December 62°F 40°F 33% 12

Figure 166 workable days a year in Hattiesburg, spread across February through June. Shoulder months turn on the overnight rule: an afternoon at 64°F passes, but the 40°F night floor is what actually opens the season in February. For the statewide picture, the Mississippi page compares peak months city by city.

July here fails on heat, not rain: the average high of 91°F sits over the 90°F label ceiling, and 31 of 31 days typically top 90°F. Midsummer work moves to dawn or waits for October.

The rain odds swing hard across the year — 22% of days in October up to 42% in July. Season the plan accordingly: prep in the wet months, apply in the dry ones.

Same-weekend planning note: the dew and overnight rules here track exterior painting in Hattiesburg almost rule for rule — a clean staining day usually paints too.

Numbers above come from NOAA's 1991–2020 normals for Hattiesburg 5Sw, Ms Us, 6.2 km from the city center — close enough that neighborhood microclimates (shade lines, river valleys, urban heat) matter more than station distance. See how these day counts are scored.

Comparing calendars along the loop? See how the season shifts for deck staining in Gulfport, MS, or jump ahead to deck staining in Jackson, MS.

Hattiesburg by the numbers

Prep checklist

  1. Pick the window first: you need roughly 2 dry days (24 h cure plus buffer), and Hattiesburg averages rain on 42% of July days versus 22% in October — the strip above finds the pair.
  2. Wash the deck, then give Hattiesburg's air 48 hours to pull the water back out — a pressure washer shortens the scrub, not the dry time.
  3. Check moisture before opening the can — under 15% on a wood moisture meter; after a July soak, end grain lags the surface by a day.
  4. Knock down splinters, set proud nails, and clear the gaps between boards — drips pool there.
  5. Tape the siding line and lay cloth drops — painter's tape where deck meets wall.
  6. Morning start, shaded side first — full sun puts a board 20–30°F above air temperature, past the 90°F ceiling on a 79°F day.
  7. Thin coats, wiped edges: pads or a pump sprayer below 15 mph wind; brush-only from 15 to 20 mph.
  8. Quit about 2 hours before sunset — Hattiesburg's October nights average 56°F, and the dew-point spread closes fastest right after dark.

Pro moves for Hattiesburg conditions

Gear that saves a window

FTC note: the gear below is unlinked until the affiliate program is switched on. See the affiliate disclosure.

Frequently asked questions

What temperature is too cold to stain a deck?

Below 50°F air temperature, or any night under 40°F inside the 24-hour cure. Cold is what actually frames Hattiesburg's season: average lows sit at 54°F in April and 56°F in October, so shoulder-season afternoons can pass while their nights fail.

How long does deck stain need to dry before rain?

About 24 hours for water-based stain, up to 48 for oil-based — rain of 0.05" or more inside that window can spot or streak the film. In Hattiesburg, July brings measurable rain on 42% of days, so finding two clean days is the real scheduling job; October (22%) makes it easy.

Can I stain a deck in direct sunlight?

Direct sun is a surface-temperature problem: add 20–30°F to the forecast for a board in full sun. With Hattiesburg July highs averaging 91°F, sunlit boards regularly pass the 90°F limit even when air temperature reads fine. Chase the shade and finish 2 hours before sunset.

How dry should wood be before staining?

Under about 15% moisture content, with no 0.05"+ rain in the previous 24 hours (and ideally 48). After a soak, Hattiesburg wood needs a full day or two of drying — longer in July, when rain returns on 42% of days. The sprinkle test works: if water beads instead of soaking in, wait.

Water-based vs oil-based stain in a wet climate?

Water-based needs a shorter dry window (24 h vs 48) — decisive where rain is frequent. Hattiesburg's wettest month sees rain 42% of days, so the shorter cure roughly doubles your usable windows; the engine marks oil's 24–48 h tail as MARGINAL when rain lands there.

What months are best for staining in MS?

The table above puts October, November and May on top; October alone averages 24 days that clear every rule. Statewide the ranking shifts with elevation and latitude — the MS state page compares every listed city month by month.

Can I stain a deck after it rains?

Yes, once the wood has fully dried — typically 24 to 48 hours of dry weather after light rain, longer after soaking storms or in shade. Boards can feel dry on top while holding moisture inside, so test first: stain applied to damp wood won't penetrate and often peels within a season. In Hattiesburg, May usually offers the most reliable back-to-back dry days.

How do I know if my deck is dry enough to stain?

Use two checks. Sprinkle water on several boards: if it soaks in within about a minute, the wood will accept stain; if it beads, the deck is too wet or still sealed. For certainty, a pin-type moisture meter should read 15 percent or below. Test shaded boards and board ends, which dry slowest, not just the sunny center of the deck.

Is it OK to stain a deck in direct sunlight?

Avoid it. Boards in full sun can run 20°F or more hotter than the air, which flash-dries stain on the surface before it penetrates, leaving lap marks, sticky spots, and early peeling. Work in the shade as it moves around the house, or stain in mid-morning after dew evaporates, keeping a wet edge and finishing complete board lengths.

Why is my deck stain sticky and not drying?

Tacky stain usually means over-application, cool damp weather, or both. Heavy coats on dense or previously sealed wood sit on the surface instead of soaking in, and humidity above roughly 80 percent or nights below 50°F stall drying further. Wipe up the excess, allow warm airflow, and expect extra days; lay oil-soaked rags flat outdoors to dry, since piled stain rags can self-ignite.

Deck Staining glossary

Wood moisture content
The percentage of water in wood by weight; decking should read 15 percent or less on a moisture meter before stain will penetrate and bond properly.
Sprinkle test
Flicking water onto bare wood to gauge readiness: absorption within about a minute means it will take stain; beading means the wood is wet or sealed.
Flash drying
When heat or direct sun dries stain on the surface before it can penetrate, causing lap marks, tackiness, and premature peeling; common above 90°F.
Lap marks
Darker stripes where wet stain overlapped stain that had already started drying; prevented by maintaining a wet edge and coating full board lengths in one pass.
Recoat window
The time frame in which a second coat bonds properly — wet-on-wet within about an hour for many penetrating stains; film-forming products often specify 4 to 24 hours.
Dew point
The temperature at which airborne moisture condenses on surfaces; stain that hasn't dried before the deck cools to the dew point can blush white or blotch.

People also search for

Other projects in Hattiesburg

Deck Staining nearby

Guides

Climatology: NOAA 1991–2020 normals via HATTIESBURG 5SW, MS US (6.2 km from Hattiesburg center, elevation 385 ft); live outlook by Open-Meteo.